Instruction manual

HOW TO SETUP HOW TO SETUP

INSTALLING INTO VEHICLE FORWARD FACING

(UPRIGHT OR RECLINED)

IMPORTANT:

DO NOT USE RESTRAINT IN FORWARD-

FACING POSITION WITH THE STABILISING

BAR PULLED OUT.

Do not recline into baby position when

using restraint in forward facing child use

mode.

Ensure harness and headrest are in the

correct position (Refer to page 38).

A. Remove the seat from the vehicle by

disengaging the seat belt and upper anchorage

strap refer to page 42.

B. Remove the Baby Infant Safety Cushion Insert

as this is no longer required.

C. To store the Stabilising Bar, lift the Seat Pad at

the end of the seat which uncovers the stabilising

bar storage recess.

D. Press button on left side (facing seat) and

gently push stabilising bar back and then down

into the recessed area.

E. Re-attach the Seat Pad at the end of the seat.

Stabilising bar

Seat

Pad

Hook and Loop attachment

1. Rotate backwards

2. Then push

inwards

F. Convert the restraint to child use mode by placing

one hand over rear corner of the base and lift the top

end of restraint with the other hand until audible click

is heard.

G. Determine whether an upright or reclined position

is preferred and adjust if necessary.

FULLY UPRIGHT CHILD USE MODE

FULLY RECLINED CHILD USE MODE

Button under trim