Instruction manual

HOW TO SETUP

H. Place one hand on the front corner of base

rmly, while with the other hand push the Grey

Recline Latch up to unlock and push back until

the restraint is at the desired position. Ensure the

Grey Recline Latch is engaged into position by

pushing on the restraint.

I. Position restraint in forward-facing mode and

align restraint centrally to the chosen seating

position as shown on page 33.

Some vehicle seat fabrics (particularly velours)

may be damaged by a child restraint used

continuously. We recommend the use of a messy

mat or thick towel to keep the vehicle seat in good

condition.

Lift Grey Recline

Latch

Engage

Seatbelt

buckle

Ensure lap part of seat

belt is below the hooks

Seat belt

lock-off lever

Lap Seat Belt

Hook

Pull sash portion of seat

belt through the lock-off

to remove slack

J. Fully lengthen seat belt. Thread the seat belt into child use seat belt path (yellow marker) as shown

below, ensuring that the seat belt is behind the harness straps and that the lap part of the seat belt is

below the hook as shown below, on each side.

NOTE: Seat belt extenders should not be used. If the seat belt is not long enough to secure the child

restraint. If they are used then the buckle tongue must not enter the seating zone.

K. Engage seat belt buckle and tongue, ensure to remove all slack from lap part of seat belt by pulling

sash belt. Adjust the seat belt to hold the restraint rmly against the vehicle seat. Feed the sash belt

into seat belt lock-off pulling the sash tight through the lock-off. Press the lock-off lever to secure the

seatbelt. For inertia/retractable seat belts, allow excess belt to feed back into retractor.

L. If using just a lap seat belt, thread the seat belt through the back of the seat following the belt path.

Keep the belt under the hook on each side. Then engage the buckle and tighten the seatbelt so the

restraint is held rmly against the car's back.

Yellow

FORWARD-

FACING

BELT PATH

label