Instruction manual

HOW TO INSTALL
36
INSTALLING INTO VEHICLE FORWARD-FACING
(UPRIGHT OR RECLINED)
N. Tighten Adjustable Upper Anchorage Strap by pulling
adjustment strap to remove slack as shown below, but
do not over-tighten causing the restraint base to lift off
the vehicle seat.
O. Roll up excess strap tightly so the webbing is thick
enough to be held in the storage band and is away from
child's reach.
M. Fit the attachment clip to the anchor tting as shown.
Make sure to remove as many twists as possible from the
upper anchorage strap. Refer to the car owners handbook
for the location of the child restraint anchor tting.
CAUTION:
Always roll up the excess strap otherwise it may hang
outside the car door or could strangle a child.
IMPORTANT:
Check that the belt is not twisted and the diagonal belt
is only clamped by the lock-off which is located on the
opposite side from the car seat buckle.
Always attach the hook and remove slack
Attachment Clip
Car's Anchor Fitting
HOW TO INSTALL
37
IMPORTANT:
Always roll up the excess Upper Anchorage Adjustment Strap.
Pull Adjustment Strap
to remove slack
Storage
Band
Press
Car's Anchor Fitting
Pull to remove
slack, then store
the strap as shown
Attachment
Clip
Storage
Band
Upper Anchorage
Adjustment Strap
M
N
O
Seat belt 'Lock-off'
Pull to
tighten belt
Child use seat belt path
Upper Anchorage
Strap
FORWARD-FACING
BELT PATH;
marked in yellow.
FORWARD-FACING
BELT PATH;
marked in yellow.
Hook