Instruction manual

42
CARE & MAINTENANCE
43
REGULAR CARE OF THIS RESTRAINT:
Please check the following items regularly to ensure the
safety of your child:
A. Check the webbing for fraying.
B. Check that the buckle clicks and is not sluggish or sticky
in operation.
C. Ensure there are no cracks in moulding or the plastic
moulding.
D. Check the harness adjuster is operating and is clamping
the webbing.
E. If any part of the restraint is cracked or broken, seek repair
immediately or replace the child restraint.
F. Ensure the buckle is free of uff, liquid or other matter that
may enter the buckle slots. If the buckle engages sluggishly,
clean it as detailed on the next page.
SEAT
Use only mild soap and water to clean all metal and plastic
parts of the restraint. Do not use chemicals or cleaning
agents.
HOW TO INSTALL
TO RECLINE RESTRAINT
The child restraint may be reclined or positioned upright
without removing the child from the restraint. Lift
Grey Recline Latch and push or pull to get the desired
recline. There are 4 recline positions. You will be able
to gain partial recline from upright position lifting the
Grey Recline Latch up and pulling the seat forward (see
page 14). The extent of the recline will be limited by the
location of the anchorage point. Loosening of the upper
anchorage strap may be required when positioning the
restraint to either an upright or reclined position. Once
the required position has been determined always tighten
the upper anchorage strap, tighten the car's seat belt and
close the Lock-off.
TO REMOVE RESTRAINT FROM
VEHICLE
A. Disengage seat belt tongue from buckle and remove
from restraint.
B. Release the stored strap and fully press Upper
Anchorage Strap Adjuster Button (A) while pulling Upper
Anchorage Strap (B) to slacken as shown right. In some
vehicles loosening of the Upper Anchorage Strap may
be difcult. If so, try pushing the restraint against the
vehicle seat back or slightly lifting the restraint to release
the tension.
C. Disengage Attachment Clip from Anchor Fitting. The
child restraint is now disconnected.
Lift Grey Recline Latch up while moving
restraint into desired recline position.
Lift Grey
Recline Latch
Fully press Adjuster Button (A)
while pulling Upper Anchorage
Strap (B) to lengthen.
B
A
Storage
Band
B