Instruction manual

46 47
CARE & MAINTENANCE
Unhook elastic loops from the
back of the restraint
H
H
D
TO REMOVE COVER:
A. Remove the restraint from vehicle.
B. Disengage harness tongues from harness buckle.
D. Remove any accessories such as the Infant Safety
Cushion Insert.
E. Remove the Seat Pad by pulling away from the cover and
peel off the Push Button Moulding.
F. Remove headrest cover by unhooking the two elastic
loops from under the headrest. Pull headrest slightly forward
and lift elastic sitting behind the headrest. Lift over and peel
headrest trim away from seat.
NOTE: The restraint is tted with Side Impact Cushions, the
headrest trim has elastic which pulls over the Side Impact
Cushions that can be easily removed and replaced.
G. Unthread the speaker cable.
Peel away
from headrest
F
Peel away
from
restraint
TO REPLACE COVER:
A. Feed the Harness Tongues and shoulder straps through Lap strap slots.
B. Stretch trim cover over the top of the restraint rst, then the sides of the child restraint, and then
stretch the cover around the rim of the restraint.
C. Re-t the Seat Cover attachments.
D. Fit headrest cover over headrest and feed harness thru open slots in cover, ensure elastic is at the
rear of headrest, behind cushions.
E. Fit the Seat Pad around the Push Button housing and feed the crotch buckle through the pad. Fit the
Seat Pad to the seat connecting with the seat cover along the seat surface and up the backrest.
F. Ret the Speaker cable as detailed on page 48.
G. Ret Infant Safety Cushion Insert, if required as detailed on the next page.
H. Ensure the harness straps are not twisted.
CARE & MAINTENANCE
H. To remove trim cover, unhook elastic trim body from behind
the restraint and at the front of the restraint next to stabilising bar.
Peel cover away from restraint.
Remove
Seat Pad
Infant Safety
Cushion Insert