Instruction manual

56
57
Consult the vehicle owner’s handbook for location of anchorage ttings or anchorage points and the
possible use of spacers. Some vehicles may have an anchor tting tted by the vehicle manufacturer.
If anchorage points cannot be found refer to car manufacturer or local child restraint tting station or
trafc authority for optimum position of anchorage point and the use of spacers.
UPPER ANCHORAGE STRAP
IMPORTANT:
THE ATTACHMENT CLIP COVER MUST ALWAYS BE USED AS IT PREVENTS THE RISK OF INCORRECT
FITMENT OF THE ATTACHMENT CLIP TO THE ANCHOR FITTING. ALWAYS ENSURE THAT THE
ATTACHMENT CLIP IS CORRECTLY ENGAGED TO THE ANCHOR FITTING AND NOT HOOKED OR
FITTED TO ANY OTHER OBJECT BEFORE EACH USE OF THE RESTRAINT. THIS IS ESPECIALLY
IMPORTANT IN VEHICLES SUCH AS STATION WAGONS, VANS, HATCH BACKS OR VEHICLES
WITHOUT A FIXED PARCEL SHELF, SINCE THE ANCHOR POINT IS USUALLY NOT VISIBLE.
IMPORTANT INSTALLATION NOTE:
In some vehicles the anchor tting in the rear vertical panel can only be installed in one way. Please
refer to vehicle owner’s handbook or a child restraint tting station for correct method.
Extension Strap distance to be measured.
Length 300mm (Use Safe-n-Sound part 0035).
Length 600mm (Use Safe-n-Sound part 0036).
Available from all major child restraint retailers.
DISTANCE TO MEASURE TO THE
ANCHOR POINT
The shaded areas of this diagram illustrate the possible locations of the anchor tting. Within each
shaded area is an anchor tting showing the correct way to install the tting. Ensure the anchor tting
is aligned as illustrated unless stated otherwise in the vehicle owner’s handbook.
Adjustable upper
Anchorage strap.
Front of Vehicle
45°
Anchorage Clip Cover
PRE-INSTALLATION ANCHOR FITTING PRE-INSTALLATION ANCHOR FITTING