Instruction manual

HOW TO SETUP
14
15
A
Then push bar
forward
Pull out
Stabilising
bar
Click
Helpful
Harness
Holder
INSTALLING INTO THE CAR
A. Place restraint rearward facing in the chosen
seating position with the Messy Mat positioned
centrally in the seating position. Remove Infant
Safety Cushion Insert, and gently remove the Seat
Pad.
B. Undo the buckle and place buckle tongues in the
Helpful Harness Holders.
C. Pull out stabilising bar and gently push bar
forward until a click is heard. Stabilising bar is now
latched in place.
Infant Safety
Cushion Insert
Remove
Seat Pad
B
C
HOW TO SETUP
D
E
D. If using a lap-sash seabelt, disengage the
rear facing Lock-off. Fully lengthen seat belt and
feed the seat belt through the closest seatbelt
path slot and pass across the seating surface
behind the crotch buckle straps and through the
opposite slot. Follow the blue - REARWARD
FACING BELT PATH label.
E. Engage seat belt buckle & tongue and tighten
the seat belt allowing the sash to fully retract.
Use the rear facing seat belt lock-offs to prevent
the seat belt loosening. See illustrations on
page 17. Do not use the lock-off if the buckle
interferes with closing the lock-off.
Note: Seat belt buckle and tongue must not rest
between restraint cover and restraint. If seat belt
buckle is adjustable, adjust buckle as low as
possible away from the restraint.
Lock-off (open)
Seatbelt path slot
Blue -
REARWARD
FACING BELT
PATH label.
Pass buckle tongue through slots 1 and 2.
2
1
Headrest trim end
Pass buckle tongue through here