Instruction manual

HOW TO SETUP
16 17
F. Ret the harness buckle through Seat Pad and
t the Seat Pad around the Push Button adjuster
moulding. Ret the Seat Pad by connecting with
the seat cover along the seat surface and up the
backrest. For smaller babies replace the Infant
Safety Cushion Insert. Do not use the Insert if the
child's shoulders reach the Lower Shoulder Height
Marker, remove the Insert for longer use whilst still
rear facing. See page 23 for advice on positioning
the shoulder straps.
HOW TO SETUP
G. Align restraint centrally to the chosen
seating position. Pull sash portion of seat belt
until all slack is removed from Lap portion
of seat belt. Adjust seat belt to hold the
restraint rmly against the vehicle seat back.
For retractor seat belts. Allow excess belt to
feed back into retractor. Lock the rear facing
seat belt lock-off to prevent the seat belt
slackening.
If placing the restraint in a seating position
with a lap only seat belt, tighten the seatbelt
so as to hold the restraint rmly against the
vehicle seat back.
On the car seat belt buckle side, pass both lap
and sash seat belt through the lock-off and lock
in place
Rear facing
seat belt
lock-off
On the opposite side to the
seat belt buckle, only pass
the lap portion of the belt
through the lock-off and
lock in place (optional).