Owner`s manual
Instructions for Installation & Use - Series number: 2030/A/2010
Instructions for Installation & Use - Series number: 2030/A/2010
HOW TO SET-UP
20
21
ANGULAR ADJUSTMENT OF CAPSULE
Some vehicle seats have more rearward slope than others. If the angle of the seat causes
thebabytobetoouprightforcomfort,theanglemaybealteredbyplacingarmpacking
betweentheseatandtheundersideoftheBase(packingcanbearmlyrolleduptowelor
nappy).
Forcarseatsthatareveryat,packingatthefrontwillcausetheBasetomorereclined.
Do not remove all of the rearward slope by over packing. Always leave a rearward slope
angle of approximately 10 to 15 degrees.
10° to 15°
Consultthecarowner’shandbookforlocationofanchorttingsoranchoragepoints.Most
modernvehicle'salreadyhaveananchorttingttedinthecar.
AnanchorttingisrequiredtoattachtheupperanchoragestraptofullyinstalltheCarrierto
the car. The upper anchorage strap must be used with this infant carrier when used in the
car.
ForinstallingtheBasetothecar,selectaseatingpositionwithachildrestraintanchortting
directly behind the seating position.
Ifthereisnochildrestraintanchorttingorchildrestraintanchorpointrefertopage38for
theinstallationoftheanchorttingaswellastheuseofextensionstraps.
REARWARD-
FACING SEATBELT
PATH
INSTALLING BASE INTO VEHICLE
A. Place the Base into the vehicle at the selected
seating position with the "PRESS" catch end
against the seat as shown below. Extend the
seat belt to maximum length. For lap-sash seat
belt, position the tongue in the middle of the fully
extended belt.
B. Feed the seat belt tongue through the slot on
the side of the Base closest to the seat belt
anchorage.
A
B
HOW TO INSTALL
Packing