User guide

42 43
BRITAX Child Safety, Inc. BOULEVARD CLICKTIGHT User Guide
7. Route the harness straps
through the seat to the
back. Ensure that the
harness straps pass over
the tube.
8. Nest the end of the left
harness strap into the
right.
9. Slide the harness straps
completely onto the yoke.
Ensure that the adjuster
and harness straps are
not twisted and that
the ends of the harness
straps are securely
attached to the yoke.
Shell • SPONGE CLEAN the
shell using warm water
and mild soap.
• TOWEL DRY.
DO NOT
• Use abrasive
cleaners.
Cover • HAND WASH the
cover using cold water
and mild soap.
• LINE DRY to prevent
the cover from
shrinking.
DO NOT
• Bleach
• Machine wash
• Machine dry
• Iron
Harness • SPONGE CLEAN the
harness using warm
water and mild soap.
• TOWEL DRY.
DO NOT
• Disassemble the
harness
• Bleach
• Machine wash
• Machine dry
• Iron
Harness
Buckle
• THOROUGHLY RINSE
the buckle using warm
water.
• TEST THE BUCKLE
by fastening and
unfastening until a
click is heard after
inserting each buckle
tongue. If clicks are
not heard, repeat the
cleaning procedure.
• TOWEL DRY
DO NOT
• Soak
• Lubricate
• Use solvents
• Use soap or
household
detergents
Cleaning
TUBE
Troubleshooting
Problem Possible Solution
The
CLICKTIGHT
will not close
with a click to
signal that
it is secure�
There may be debris or other objects
interfering with the mechanism.
Ensure the seat area is clear of any
obstructions and try closing the
CLICKTIGHT again.
There may be too much tension in
the belt/strap. Do not overtighten
the belt/strap before closing the
CLICKTIGHT. Only remove slack.
The logo on the
CLICKTIGHT dial
will not return
to a horizontal
position�
Press down again on the
CLICKTIGHT to the left and right of
the bezel to ensure the CLICKTIGHT
pins have fully engaged.
The harness
adjuster button
will not operate�
There may be debris in the
mechanism. Clean the mechanism,
then try using the button again.
The harness
cannot be
adjusted to its
full height�
Check the seating position where
the child seat is installed. The vehicle
head restraint may obstruct the path
of the child seat harness height
adjuster. Remove or raise the vehicle
head restraint and try adjusting the
harness height again.
The harness
length is too
short�
Harness length can be extended if
necessary for children over the age
of 2. For more information, contact
BRITAX Consumer Services at 1-888-
427-4829 or 1-704-409-1699.
The harness is
hard to adjust�
The harness may be at maximum or
minimum height, the harness may
be too tight to adjust, or the child’s
weight may be pressing against the
head pad. Check for and correct all
of the above where necessary and
try adjusting the harness again.
The adjuster
strap is fraying
at the sides�
Pull the harness adjuster strap up and
away from the child seat to tighten.
Do not pull sideways. Doing so may
cause the harness adjuster strap to
fray at the sides. See page 21.
The buckle will
not fasten with
a click after
each tongue is
inserted�
There may be debris in the buckle
mechanism. Clean the buckle (see
page 42), then try fastening the
buckle again.
Please contact BRITAX Consumer Services at 1-888-427-
4829 or 1-704-409-1699 if you have an issue not listed
here.