User manual

Installation: Rear Facing
12
7 With one hand, push the child
restraint firmly into the vehicle seat
while pulling the first LATCH con-
nector strap tight (fig D).
8 Continue pressing child restraint
firmly into the vehicle seat while
pulling the second LATCH connector
strap tight.
9 Verify that all connections are
tight and the child restraint is secure.
10 If desired, attach Versa-Tether
as instructed on pages 27-28.
Rear facing installation is improved by the use of the Versa-Tether
,
but it is not required.
Important
Always store LATCH connectors when not in use by attaching to
storage rings on the side of the child restraint.
Rear facing installation is improved by the use of the Versa-
Tether
, but it is not required.
If you have a problem stabilizing your child restraint, place a rolled
towel in the crease of the seat to help level the child restraint base.
Warning
DO NOT raise the base beyond horizontal or off of the vehicle
seat, doing so will reduce the protection for your child.
Removal
To remove the child restraint, release both LATCH connectors from
the LATCH anchors by pressing the red button.
If connected, disconnect the Versa-Tether
from the tether anchor.
Always store LATCH connectors when not in use by attaching to
storage rings on the side of the child restraint.
D
FAGalaxy_page proof 2/9/02 11:17 AM Page 12