User manual

Installation: Rear Facing

Rear Facing Lap Belt Installation

1 Recline child restraint as necessary to

align leveling line horizontal with the

ground.

IMPORTANT:

Only use super recline

mode if necessary to obtain proper

angle, based on vehicle seat contour

(see page 29).

2 Unhook hook and loop attachments on

the front edge of the cover, then pull the

stabilizing bar out completely. Pull stabiliz-

ing bar upward until it clicks into position

(fig. A).

IMPORTANT:

Stabilizer bar must always

be extended when seat is rear facing.

NOTE:

Do not reattach cover with hook

and loop until seat belt has been rout-

ed.

3 Place the child restraint rear facing on

the vehicle seat.

Fully extend the vehicle seat belt, then

pass it through the closest rear facing belt

slot.

Route belt in front of the buckle strap, then through the second rear

facing belt slot

(fig. B)

Fasten the seat belt, then verify that the seat belt is not twisted

(fig. C).

FAGalaxy_page proof 2/9/02 11:17 AM Page 15