User Guide

Installation: Versa-Tether

Using the Versa-Tether Forward Facing

1 Remove tether from pouch.

2 Press and hold the tether adjuster release button, then pull to fully

extend tether strap into a V-shape.

3 Locate the hook on the tether strap.

Loosely attach the tether to an approved tether anchor point

for the desired restraint installation position (fig. A).

5 Secure the child restraint in the vehicle.

Pull the tether adjuster strap to remove all slack.

Verify that there is tension in the tether strap and that child

restraint is properly secured.

Using the Versa-Tether Rear Facing

1 Secure the child restraint in the vehicle.

2 Remove tether from pouch.

3 Press and hold the tether adjuster

release button, then pull to fully extend

tether strap into a V-shape.

4 Locate the hook on the tether strap.

Loosely attach the tether to an

approved tether anchor point for the

desired restraint installation position (fig. B or C).

Pull the tether adjuster strap to remove all slack.

Verify that there is tension in the tether strap and that child

restraint is properly secured.

Using the Rear Facing Tether Connector Strap

If you cannot find a suitable location to anchor the tether, use the

tether connector strap to create an anchor point.

WARNING: Only use the tether connector strap (fig. D) for rear facing tether

installation.

1 Find a fixed vehicle seat belt anchor or vehicle seat leg, that is

bolted to the floor, that the strap can be wrapped around.

2 Loop the strap around the metal anchor (fig. D).

3 Take the metal D-ring and thread it through the webbing loop on

the other end of the strap.

4 Pull the metal D-ring all the way through until the strap is tight

around the metal anchor.

5 Use the D-ring as an attachment point for the hook on the tether

strap.

Rear Facing Location (Swedish)

Rear Facing Locations (Australian)

Forward Facing Locations

22 23

P2500_R01b.qxd 12/7/2004 9:31 AM Page 24