User Guide
Care and Maintenance
35
Care and Maintenance
34
Cover Removal
1 Remove Toddler Pillow by unhooking each attachment clip.
2 Remove Body Pillow.
3 Loosen the harness by pressing the harness adjuster button while
pulling the shoulder straps forward as far as possible.
4 Unhook the shoulder straps from the yoke on the rear of child
restraint.
5 Pull upper harness straps through the shell, cover, and infant pillow
to the front of the restraint.
6 Remove infant pillow from harness straps.
7 Remove the belly pad from the harness buckle.
8 Gently remove the upper portion of the cover. Be careful not to
damage the energy absorbing foam.
9 Pull the lower harness straps, buckle tongues, chest clip, and
harness buckle through the slots in the cover.
WARNING:
•
Do not take apart or attempt to take apart the harness. It is
unnecessary and dangerous to do so.
•
Never remove the buckle tongues from the harness. They cannot be
reattached after removal.
10 Remove the entire cover from the restraint.
Refitting the Cover
To refit the cover, reverse Cover Removal directions.
Make sure that
the shoulder straps are threaded through the chest clips and that
the harness is not twisted.
Cleaning the Cover and Pillows
•
HAND WASH,
using cold water and mild soap.
•
LINE or LIE FLAT DRY, to prevent cover from shrinking.
•
DO NOT:
Bleach, machine wash, machine dry, or iron.
Cleaning the Shell
•
SPONGE CLEAN, using warm water and mild soap.
•
TOWEL DRY
•
DO NOT:
Use solvents, abrasive cleaners, or disassemble the
harness.
Cleaning the Harness
•
SPONGE CLEAN, using warm water and mild soap.
•
TOWEL DRY
•
DO NOT:
Bleach, machine wash, machine dry, or disassemble
the harness.
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it is clean and free
of food, coins, dirt, and other objects.
If debris is present, it must be
removed to prevent interference with the adjuster mechanism.
•
BRUSH AWAY LOOSE DEBRIS, using a soft bristled brush.
•
SPONGE CLEAN, using warm water and mild soap.
•
TOWEL DRY
•
DO NOT:
Use solvents, abrasive cleaners, or disassemble the
harness.
P2500_R01b.qxd 12/7/2004 9:32 AM Page 36