Instruction manual

Instructions for Installation & Use - Series No. 4900/A/2010
38
The shaded areas of this diagram illustrate the possible locations of the anchor tting.
Within each shaded area is an anchor tting showing the correct way to install the tting.
Ensure the anchor tting is aligned as illustrated unless stated otherwise in the vehicle
owner’s handbook.
Extension Strap distance to be measured.
Length 300mm (Use Safe-n-Sound part 0035 or equivalent).
Length 600mm (Use Safe-n-Sound part 0036 or equivalent).
Available from all major child restraint retailers.
Distance to measure
to the anchor point
Adjustable Upper
Anchorage Strap.
Front of Vehicle
45°
INSTALLATION OF CAR ANCHOR FITTING
THE ATTACHMENT CLIP COVER MUST ALWAYS BE USED AS IT PREVENTS THE
RISK OF INCORRECT FITMENT OF THE ATTACHMENT CLIP TO THE ANCHOR FITTING.
ALWAYS ENSURE THAT THE ATTACHMENT CLIP IS CORRECTLY ENGAGED TO THE
ANCHOR FITTING AND NOT HOOKED OR FITTED TO ANY OTHER OBJECT BEFORE
EACH USE OF THE RESTRAINT. THIS IS ESPECIALLY IMPORTANT IN VEHICLES SUCH
AS STATION WAGONS, VANS, HATCH BACKS OR VEHICLES WITHOUT A FIXED
PARCEL SHELF, SINCE THE ANCHOR POINT IS USUALLY NOT VISIBLE.
IMPORTANT WARNING:
Consult the vehicle owner’s handbook for location of anchorage ttings or anchorage
points and the possible use of spacers. Some vehicles may have an anchor tting tted by
the vehicle manufacturer. If anchorage points cannot be found refer to car manufacturer or
local child restraint tting station or trafc authority for optimum position of anchorage point
and the use of spacers.
UPPER ANCHORAGE STRAP
IMPORTANT INSTALLATION NOTE:
In some vehicles the anchor tting in the rear vertical panel can only be installed in one way.
Refer to vehicle owner’s handbook or a child restraint tting station for the correct method.