Owner`s manual

Instructions for Installation & Use - Series No. 40/A/2013 Instructions for Installation & Use - Series No. 40/A/2013

SUITABLE FOR USE

Do not use on any vehicle seat which faces sideways or rearwards.

DO NOT USE A REAR-FACING CHILD RESTRAINT WHERE AN AIRBAG IS FITTED

IN FRONT OF THE SEATING POSITION. For other airbags, refer to the car owner’s

handbook for warnings and instructions.

Seat belt extenders should not be used if the seat belt is not long enough to secure the

child restraint. If seatbelts are too short the advise should be sought from a child restraint

fitter and thier recommendedations considered before using a seatbelt extender. If they

are used then the buckle must sit above the base moulding.

THE TETHER STRAP MUST ALWAYS BE FITTED WHEN THE CHILD RESTRAINT IS

USED IN A VEHICLE.

Do not use the restraint without the top tether strap correctly attached.

The top tether strap must be attached to an anchorage point using an extension strap if

necessary.

The Infant Carrier may just touch the front seat, but must not in such a way that the

installation angle is affected.

Do not recline the seat excessively, it must be installed at the correct angle (see page

25 - 26).

USING THE INFANT CARRIER

REMOVING INFANT CARRIER FROM BASE

A. Grasp the handle with one hand. With the other

hand, lift the catch located at the front of the Infant

Carrier.

B. With the catch still lifted raise the Infant Carrier

clear of the base.

Pull

Catch

Lift