Owner`s manual

Instructions for Installation & Use - Series No. 40/A/2013 Instructions for Installation & Use - Series No. 40/A/2013
22
23
To avoid pinching your fingers follow the steps
above.
A. Squeeze the carry handle release latch on
each side of the handle and rotate to the first
position-“rocking position” .
B. Squeeze the latch again and start to rotate the
handle then remove both hands from the latches
and use one hand at the top of the handle to rotate
down further until the handle latches in the second or
“non-rocking position” . The carrier is now locked to
the stroller.
ADJUSTMENT OF HANDLE POSITION WITH BRITAX CLICK
& GO™ ADAPTOR
2
3
Push down until it clicks into place.
3
A
B
2
3
USING THE INFANT CARRIER USING THE INFANT CARRIER
2
ADJUSTMENT OF HANDLE POSITION
The Unity™ Travel System Infant Carrier features a sturdy carry handle which can be
used in conjunction with the curved base to convert it to a rocker. At the base of the
handle there are two large buttons which control the three positions of the handle. These
positions are the "carry (or travel) position" , the "rocking position" , and the
"non-rocking position" .
B. Ensure the handle is locked in position securely.
The "rocking position" enables the Infant Carrier
to rock without the possibility of the Infant Carrier
tipping over.
C. To convert to a "non-rocking" position depress
both buttons and rotate the handle to the fixed
position. Ensure the handle is locked in position
securely.
A. To convert from carry to "rocking position" ,
depress the large buttons on each side and rotate
the handle towards the front of the Infant Carrier.
When you have started rotating the handle release
the buttons and continue rotating the handle round
until it locks into position.
Rocking Position
Non-rocking
Position
Carry Position
Do not place the Infant Carrier on a table or a
work-top where it could fall off.
IMPORTANT :
2
3
1
3
1
2
2
3