Owner`s manual

Instructions for Installation & Use - Series No. 40/A/2013 Instructions for Installation & Use - Series No. 40/A/2013
26 27
Always leave a
rearward slope angle of
approximately 10° to 15°
MANUAL PACKING
The angle may also be altered by placing a firm packing between the seat and the
underside of the base (packing can be a firmly rolled up towel or nappy)
For some vehicles with flat seats some packaging may be required at the front edge of
the base to get some recline. The stabilising bar does not need to touch the car's seat
back but should be close.
Always leave a rearward slope angle of approximately 10° to 15°
ROAD
ROAD
Packing
10° to 15°
10° to 15°
INSTALLING THE BASE
Blue REARWARD-
FACING
BELT PATH label
Belt Guide
Hooks
HOW TO INSTALL BASE
USING LAP SASH SEATBELT
A. Place the base into the car in the
selected seating position with the
Stabilising bar against the vehicles
seat back as shown.
Confirm the base angle as desired,
otherwise adjust as shown on page
25 to 26.
B. Extend the seat belt to maximum
length. For a lap-sash seat belt,
position the tongue in the middle
of the fully extended belt. Feed the
seat belt through the blue REAR-
FACING SEATBELT PATH labels
on each side and under Belt Guide
Hooks.
HOW TO INSTALL THE BASE
- WITH SEATBELT
SEATBELT
REARWARD FACING