Owner`s manual

ManualsBrandsBritax ManualsAutomotiveUnity

Instructions for Installation & Use - Series No. 40/A/2013 Instructions for Installation & Use - Series No. 40/A/2013

INTRODUCTION

INDEX

WARNINGS AND IMPORTANT MESSAGES

SHOULDER HEIGHT MARKERS AND A GROWING CHILD

SHOULDER HEIGHT MARKERS AND THE NEXT STEP

SPECIAL FEATURES

SUITABLE FOR USE

USING THE INFANT CARRIER

INSTALLING THE BASE

HOW TO INSTALL THE BASE - WITH SEATBELT

HOW TO INSTALL - TOP TETHER STRAP

HOW TO INSTALL THE BASE - WITH ISOFLEX CONNECTORS

HOW TO REMOVE THE BASE - ISOFLEX CONNECTORS

INFANT CARRIER SETUP

HOW TO USE

HOW TO INSTALL IN AN AIRCRAFT

CARE & MAINTENANCE

ACCESSORIES

INSTALLATION OF CAR ANCHOR FITTING

ALTERNATIVE INSTALLATION IF SEATBELT LOOSENS

TRAVEL SYSTEM

TRAVEL SYSTEM - INTEGRAL LATCH

TRAVEL SYSTEM - BRITAX CLICK & GO™ADAPTOR

IN CASE OF CRASH

The Infant Carrier and base is installed so that the infant is facing rearwards. This

provides best position in a crash for infants.

This Infant Carrier provides the ability to fit low birth weight or premature babies and has

been tested with a special dummy to verify its capability.

No child restraint can guarantee absolute protection from injury in every crash. However,

to ensure that your child gets all the protection designed into the restraint, PLEASE

READ AND FOLLOW THESE INSTRUCTIONS EXACTLY and use only Safe-n-Sound

recommended parts and accessories.

Carefully read all the instructions for installation in this book. If in doubt about the method

of installation, consult Britax childcare or agent or a child restraint fitter or, in New

Zealand, to consult the agent for the vehicle.

If you have purchased this product with ISOFIX compatibility, the base is fitted with

ISOFLEX™ connection straps on each side, with an ISOFIX compatible connector and

tension indicators.

If fitted with the ISOFLEX™ connectors, the base may also be fitted to a centre position

using the car's seatbelt.

The Infant Carrier is suitable for fitting to a variety of Britax, Steelcraft and BOB Strollers

using one of the adaptor systems. For compatible Strollers refer to www.britax.com.au.

Britax Click & Go™ Adaptor is required for some strollers.

Britax Childcare Pty. Ltd. continues to provide care for your children when travelling in

motor cars with a range of child restraints suitable throughout their childhood.

Regional Road Rules restrict the use of child restraints, like this Infant Carrier, in the

front seat of the car. Check your local Road Rules.

Always store the instruction book in the place provided in the base when the Infant

Carrier is removed.

PAGE