Installation Sheet

ManualsBrandsBrizo ManualsKitchen FaucetsBrizo Litze 1.8 GPM Single Hole Pre-Rinse Pull Down Kitchen Faucet

ARTICULATING KITCHEN FAUCET

LLAVE DE AGUA/GRIFO ARTICULADO PARA

COCINAS

ROBINET ARTICULÉ POUR ÉVIER DE CUISINE

LITZE™& SOLNA

Models/Modelos/Modèles

For easy installation of your Brizo

faucet you will need

to READ ALL warnings, care, and maintenance information

before beginning.

Installation Requirements:

Hole Diameter: 1 3/8" ± 1/4"

Maximum Deck Thickness: 3" (76 mm)

• With Escutcheon: 2 3/4" (70 mm)

• Thin Gauged Sinks: Use Thin Deck Aid RP37490

Write purchased model number here.

Escriba aquí el número del modelo comprado.

Inscrivez le numéro de modèle ici.

10/31/2019 Rev. C

92895

pSpecify Finish/Especifíque el acabado/Précisez le fini

63143LFp

63243LFp

63144LFp

63244LFp

RP71451p

Escutcheon

Chapa

Plaque de finition

Accessory Order Only

Solo para ordenar accesorios

Accessoire livrable séparément

www.brizo.com

1-877-345-BRIZO (2749)

brizosupport@brizo.com

Para facilitar la instalación de su grifo Brizo®, antes de

comenzar deberá LEER TODAS las advertencias, infor-

mación sobre el cuidado y el mantenimiento.

Requisitos para la instalación:

Diámetro del agujero: 1 3/8" ± 1/4"

Grosor máximo de la encimera: 3" (76 mm)

• Con la chapa de cubierta: 2 3/4" (70 mm)

• Para encimeras de menos grosor: Use la pieza para

encimeras delgadas RP37490

Pour installer votre robinet Brizo

facilement, vous devez

LIRE TOUTES les mises en garde ainsi que les instructions

d’entretien et de maintenance avant de débuter.

Exigences d’installation :

Diamètre du trou : 1 3/8 po ± 1/4 po

Épaisseur maximale de la plage : 3 po (76 mm)

• Avec plaque de finition : 2 3/4 po (70 mm)

• Éviers minces : utilisez la plaque de renfort RP37490

For product & installation questions, do not return to the store. For additional help, contact customer service.

Si tiene preguntas sobre el producto y su instalación, no acuda a la tienda. Para ayuda adicional, comuníquese con el departa-

mento de servicio al consumidor.

Si vous avez des questions au sujet du produit et de l’installation, ne retournez pas au magasin. Pour obtenir de l’aide, commu-

niquez avec le service à la clientèle.

RP79275p

Soap/Lotion Dispenser

Dispensador de jabón/loción

Distributeur de savon ou de lotion

63121LFp

63221LFp

Summary of content (8 pages)

PAGE 1
ARTICULATING KITCHEN FAUCET LLAVE DE AGUA/GRIFO ARTICULADO PARA COCINAS ROBINET ARTICULÉ POUR ÉVIER DE CUISINE 92895 LITZE™& SOLNA® Models/Modelos/Modèles Accessory Order Only Solo para ordenar accesorios Accessoire livrable séparément 63121LFp 63221LFp 63143LFp RP79275p Soap/Lotion Dispenser Dispensador de jabón/loción Distributeur de savon ou de lotion 63144LFp 63243LFp RP71451p Escutcheon Chapa Plaque de finition 63244LFp Write purchased model number here.
PAGE 2
You may need: Usted puede necesitar: Articles dont vous pouvez avoir besoin: 1 1/8" 1 1 2 OPTIONAL ESCUTCHEON INSTALLATION / INSTALACIÓN OPCIONAL DE UNA CHAPA / INSTALLATION DE LA PLAQUE DE FINITION FACULTATIVE 1 2 1 2 2 3 3 3 4 4 4 Place escutcheon (not included) and gasket under faucet base. From underneath, install nuts and washers onto studs. Use deck aid (not included) for thin gauged sinks. Secure faucet to sink with mounting bracket and nut, mount underneath sink, hand tighten.
PAGE 3
A. B. OR 2 O 1 1 3 2 3 OU 4 A. Standard Connections B. NOTICE NOTICE To avoid risk of property damage, Follow instructions for proper installation. Failure to follow these instructions may result in risk of property damage caused by leaking at this connection. Do not use pipe dope or other sealants on water line connections. Ensure all fittings and end connections are free of debris. Faucet fittings (1) are 3/8" compression. Loop tubing (2) if it is too long.
PAGE 4
Correct method Método Correcto Bonne méthode Incorrect Installation Instalación Incorrecta Installation Incorrecte 2 3 1 4 NOTICE Failure to use plastic sleeve (ferrule) in the correct orientation will result in disconnection and possible water damage. 1. Determine desired length of supply tube (1). Leave 1" or 2" of extra length to allow for easier installation and cut tube. Ensure cut is straight and burr free. 2. Slide nut (2) and plastic sleeve (ferrule) (3) onto cut supply tube.
PAGE 5
4 5 2 1 1 2 2 1 Turn faucet handle on, open hot and cold water lines. Flush lines in bucket. Gire la manija de la llave de agua/grifo para abrir las líneas de agua caliente y fría. Deje que el agua corra por la líneas y caiga en un cubo o balde. Tournez les manettes pour ouvrir le robinet. Rétablissez l’alimentation en eau chaude et en eau froide. Rincez les conduites en laissant l’eau couler dans un seau. Shut off hot and cold water lines. Turn faucet handle off.
PAGE 6
Backflow Protection System 7 Your Brizo® faucet pull-down spout incorporates a backflow protection system that has been tested to be in compliance with ASME A112.18.3 and ASME A112.18.1 / CSA B125.1. It incorporates two certified check valves in series, which operate independently and are integral, non-serviceable parts of the wand assembly. Should your local plumbing codes require an atmospheric type vacuum breaker one must be purchased separately.
PAGE 7
1 1 4 4 2 6 3 5 10 9 8 7 6 Maintenance If faucet exhibits very low flow – TURN OFF WATER SUPPLIES. Unscrew adapter (1) & knurled knob (4) from spray head and clean debris from sprayer inlet (2). To remove spray head from hose, turn adapter (1) counterclockwise. Then, press button (3) and turn knurled knob (4) counterclockwise. If faucet leaks from under handle or from spout outlet – TURN OFF WATER SUPPLIES. Insert a small screwdriver into slot (5) in button (6) and remove.
PAGE 8
Limited Warranty on Brizo® Faucets Parts and Finish All parts (other than electronic parts and batteries) and finishes of this Brizo® faucet are warranted to the original consumer purchaser to be free from defects in material and workmanship for as long as the original consumer purchaser owns the home in which the faucet was first installed or, for commercial users, the warranty period is ten (10) years for multi-family residential (apartments and condominiums and five (5) years for all other commercial us