Operation Manual

Page 10

PRODUCT OVERVIEW

Remote Control

The remote control provided requires two (2) AAA batteries. Install batteries

before operating.

item Function DeScription

1 Power Power on or off

2 DEV Enable/disable remote control

3 Alphanumeric Buttons Same as alphanumeric buttons on front panel

Same as MENU button on front panel

ESC

Same as ESC button on front panel

6 REC Same as REC button on front panel

PLAY

Same as PLAY button on front panel

Direction/Enter

Same as direction buttons on front panel

PTZ

Same as PTZ button on front panel

Same as PREV button on front panel

DEV

1 2 3

4 5 6

7 8

ESC

REC PLAY

PTZ PREV

Troubleshooting Remote Control

Make sure batteries are properly installed and that the remote is aimed directly at the IR

receiver on the front panel. If remote still does not work properly, take the following steps:

1. Go into Menu > Settings > General > More Settings by operating the front control panel or

the mouse.

2. Check and remember DVR ID#. The default ID# is 255. This ID# is valid for all IR remote

controls.

3. Press the DEV button on the remote control.

4. Enter the DVR ID# in step 2.

5. Press the ENTER button on the remote.

If the Status indicator on the front panel turns blue, the remote control is operating properly.

If the Status indicator does not turn blue and there is still no response from the remote,

please check the following:

1. Batteries are installed correctly and the polarities of the batteries are not reversed.

2. Batteries are fresh and not out of charge.

3. IR receiver is not obstructed.

If the remote still cannot function properly, please change the remote and try again, or

contact the device provider.

1 2