Operation Manual

Page 19
INITIAL SETUP
Customized Protocols
After the adding of the IP cameras, the basic information of the camera
lists in the page, you can configure the basic setting of the IP cameras.
1. Click the icon to edit the parameters; you can edit
the IP address, protocol and other parameters.
Channel Port: If the connected device is an encoding device
with multiple channels, you can choose the channel to connect
by selecting the channel port No. in the dropdown list.
2. Click OK
3. (For the encoders with multiple
channels only) check the checkbox of
Channel No. in the pop-up window,
as shown in the following figure,
and click OK to finish adding
Editing the Connected IP Cameras and Configuring
To edit advanced parameters:
1. Drag the horizontal scroll bar to the
right side and click the
icon.
2. Edit the network information and
the password of the camera.
3. Click Apply to save the settings and click OK