Operation Manual

Page 23
LIVE VIEW
NOTE
:
Connect the camera to the device for the video
quality diagnostics.
Three exception types can be diagnosed:
Blurred Image, Abnormal Brightness and Color
Cast.
Adjust Live View Settings
1. To configure Live View settings (such as the Output interface, dwell time, mute or audio on, or screen number for each
channel), Enter the Live View interface: Menu > Configuration > Live View.
Setting Function
Video Output Interface Designates output settings for HDMI and VGA
Live View Mode Designates the Display Mode to be used for Live View
Dwell Time
Time (in seconds) to delay between switching
channels when enabling auto-switch in Live View
Enable Audio Output
Enables/disables audio output for the selected camera in
the live view mode.
Event Output Designates the output to show event video
Full Screen Monitoring
Dwell Time
Time (in seconds) to show alarm event screen
2. Set the camera order.
1) Select View tab.
2) Click a window to select it, and then double-click a camera name
in the camera list you would like to display. Setting an ‘X’ means
the window will not display any camera.
3) You can also click
to start live view of all channels in order and
click to stop live view of all channels. Click or
to go to
the previous or next page.
4) Click the Apply button.
Manual Video Quality Diagnostics
The video quality of the analog channels can be diagnosed manually and
you can view the diagnostic results from a list.
1. Enter the Manual Video Quality Diagnostics interface.
Menu> Manual >Manual Video Quality Diagnostics
2. Check the checkboxes to select the channels for diagnostics.
3. Click the button Diagnose, and the results will be displayed on a
list. You can view the video status and diagnostics time of the selected
channels.
User Logout
After logging out, the monitor turns to live view mode. After logging out
of the system, menu operation on screen is invalid. It is required to input
a username and password.
1. Enter Shutdown Menu: Menu > Shutdown.
2. Click Logout.