Operation Manual

Page 58
Configuring Email
ALARM SETTINGS
Before you configure email settings
Make sure you have configured the IPv4 Address,
IPv4 Subnet Mask, IPv4 Gateway and the Preferred
DNS Server in the Network Settings menu. Please
refer Configuring General Settings for detailed
information.
Email notifications can be sent to all designated users
when an alarm event is detected, when a motion event is
detected, or when the administrator password is changed.
To configure emails, enter the Network Settings interface:
Menu > Configuration > Network.
1. Click on Email.
4. Configure the settings according to the list below.
5. Click Apply.
Enable Server Authentication: Optional.
User name: user account of sender’s Email for SMTP server
authentication.
Password: password of sender’s Email for SMTP server
authentication.
SMTP Server: IP address or host name
SMTP Port No: The default TCP/IP port used is 25.
Enable SSL: Optional.
Sender: Name of sender.
Sender’s Address: Email address of sender.
Select Receivers: Select the receiver.
Receiver: Name of user to be notified.
Receiver’s Address: Email address of notified user. Up to 3
can be configured.
Enable Attached Pictures: Enabling allows alarm images to
be attached to emails.
Interval: Time (in seconds) between two actions of sending
attached pictures.
6. Clicking Test will display one of the following messages.