Operation Manual

Page 65

Conﬁguring RTSP

The Real Time Streaming Protocol (RTSP) controls

streaming media servers. To conﬁgure, enter the

Network Settings interface: Menu > Conﬁguration >

Network > More Settings.

1. Enter the RTSP port in the RTSP Service Port ﬁeld

(the default RTSP port is 554).

2. Click Apply.

NETWORK SETTING

Conﬁguring Remote Alarm Host

With a remote alarm host conﬁgured, the DVR will send

the alarm event or exception message to the host when an

alarm is triggered. The remote alarm host must have the

Network Video Surveillance software installed.

To conﬁgure, enter the Network Settings interface: Menu >

Conﬁguration > Network > More Settings.

1, Enter Alarm Host IP and Alarm Host Port.

2. Click Apply.

The Alarm Host IP refers to the IP address of the

remote PC on which the CMS (Client Management

System) software (e.g., Smartbridge High Deﬁnition) is

installed.

Alarm Host Port must be the same as the alarm

monitoring port conﬁgured in the software (default port is

7200).

Conﬁguring Multicast

The multicast can be conﬁgured to realize live view for

more than 128 cameras through network.

A multicast address spans the Class-D IP range of

224.0.0.0 to 239.255.255.255. It is recommended to use the

IP address ranging from 239.252.0.0 to 239.255.255.255.

1. Enter the Network Settings interface.

Menu > Conﬁguration > Network

2. Select the More Settings tab to enter the More Settings

interface.

3. Set Multicast IP. When adding a device to the CMS

(Client Management System) software, the multicast

address must be the same as the DVR’s multicast IP.

4. Click Apply