Installation manual

Revision F • 3/12
HARRIS CORPORATION
2-10
2 Hardware Installation
FM Analog Broadcast Input on an HDX-FM
Exciter
AUDIO INPUTS
MAIN
AES
ANALOG L/
MONO
ANALOG R/
AUX AES
SCA AUDIO
GND pin 1
#1 pins 2,3
#2 pins 4, 5
HDE-200 Network and USB Connections
2.3.9 NETWORK CONNECTIONS
The HDE-200 does not require that a computer
be networked with it at all times, but one is re-
quired to set up the HDE-200’s network settings,
the Diversity Delay and Profanity delay settings
and the other HDE-200 operational settings.
The admin computer can be any laptop or desk-
top computer with an Ethernet port, running
Windows
TM
XP (SP2 or later), Vista Pro, or Win-
dows 7 Pro, and the HDE-200 Exporter Control
Center (ECC app). It can directly connect to any
of the three Ethernet ports on the HDE-200 for
complete security. The other two ports can be used
to connect the HD Radio Exciter and an HD
Radio Importer.
Any of the HDE-200 Ethernet ports can alter-
nately be connected into a facility LAN in order
to use an engineering department computer as the
admin computer.
Note: The HDE-200’s network set-
tings must be set before it is connected
into the facility’s network. This is done
either directly from the ECC app or
by using a USB flash drive (the flash
drive supplied with the HDE-200 can
be used for this purpose). The flash
drive plugs into the rear USB port on
the HDE-200 to first capture the cur-
rent settings and to then upload new
configuration settings by resetting the
HDE-200. Refer to the
Software chap-
ter for network configuration details.
Once the HDE-200’s network settings have been
changed from the default settings, the admin com-
puter can be networked with the HDE-200 and
the ECC app used to set the various HDE-200
configurations directly over the network. These set-
tings are then maintained in the HDE-200 using
flash memory.