Installation manual

Revision F • 3/11
HARRIS CORPORATION
3-5
3 Control Center Software
name is valid, the displayed name will auto-
matically update to append the local com-
puter name to the username
(LOCAL_COMPUTER\ jcommissioner).
f) Click
OK to close the Properties window.
To remove a user, open up the properties win-
dow for that group. Click on a name to highlight
it, then click
Remove.
As an administrator , always log off the computer,
once the user group privileges have been set, so
that the next person logging in has the proper ac-
cess to the ECC app.
3.3 Starting the ECC App
An ECC app shortcut icon was
added to the computer’s desktop
during installation. Double-click
the icon to launch the ECC app.
Alternately, use the Windows Programs menu
to start the ECC app:
Start > Programs > Harris
Corp >
FlexStar > HDE-200 Control Center .
The first time the ECC app is run
(No Device) is
shown in the title bar. This indicates that an HDE-
200 has yet to be selected as the monitor source.
If any HDE-200s are already configured and
connected to the network (see page 2-10 for con-
nection information), select an HDE-200 to moni-
tor by clicking
Device > Select Device to open the
Exporter Device Browser window.
NOTE: If the admin computer has
multiple NICs, verify the correct NIC
is assigned as the Flexstar Network
Interface in the
System > Preferences
pop-up window (see page 3-21).
Main Window, with no HDE-200 Selected
Exporter Browser Window