Installation manual
Revision F • 3/12
HARRIS CORPORATION
3-6
3 Control Center Software
The Exporter Browser Window shows all of the
Harris HDE-200s it has detected on the local net-
work. To select a device double-click on its name
(or click to highlight its entry, then click
OK
, or
press
Enter
on the keyboard) to select that HDE-
200 and close the window.
The selected HDE-200’s current status and con-
figuration information is transferred to the ECC
app. If audio is going through that HDE-200, the
audio meters will show the audio levels for the
Analog and Digital Main Programs.
If a new HDE-200 is being added to the net-
work, then the HDE-200 must typically first be
configured for the facility’s network, off-line, be-
fore being physically connected to the network and
subsequently appear in this list.
Network configuration can be done in two ways:
by using a USB flash drive to copy and move the
HDE-200 configuration information to the ECC
app for editing (the “sneaker net” method); or by
setting the NIC on a computer running the ECC
app to be 10.10.10.2 so it can be directly net-
worked with the new HDE-200 (“direct” method).
Here are the default network settings assigned
to the HDE-200 at the factory:
NOTE: These settings will most likely
NOT match those needed by the
HDE-200 to function in an existing
network. DO NOT CONNECT the
new HDE-200 to your network until
its network settings are changed us-
ing the following procedure.
3.4 Editing the HDE-200
Network Settings
To edit the network settings for a new HDE-
200 using the “direct” method, install the ECC app
onto a laptop or desk computer with the IP ad-
dress of 10.10.10.2. Directly connect the computer
to port 1 on the new HDE-200. Then select the
new HDE-200 in the
Device
>
Select Device
browser window (shown on page 3-5). Select the
System
>
Address Configuration Utility
to open
the Configuration Window and follow the instruc-
tions from step 5 onwards to edit the network set-
tings.
When the ECC app is running on a networked
computer that is already connected to other
Flexstar devices, use the “sneaker net” method by
using a USB flash drive to move the settings from
the new HDE-200 to the computer by following
the instructions from step 1 onwards.
NOTE: With either method the ECC
app must be set for no security, or you
must be logged in as a Commissioner,
in order to edit the network settings
on the new HDE-200.
1. Insert a blank USB flash drive, 32 MB or
larger, into the new HDE-200’s USB port
(rear panel, near the Ethernet jacks). Wait a
minute for the HDE-200 to detect the flash
drive and to write its current configuration
settings to the drive. Various
.xml
files are
saved in a folder, labeled by that HDE-200’s
MAC address, inside a new
HDE200
folder.
Flash Drive Folder with the HDE-200 Files
HDE-200 Default Network Settings
Device IP Address
HDE-200 CPU 10.10.10.10
HDE-200 DSP 10.10.10.22
HDE-200 Gateway 10.10.10.1
HD Radio Exciter 10.10.10.11
HD Radio Importer 10.10.10.9
HDE-200 Net Mask: 255.255.255.0