Installation manual

Revision F • 3/12
HARRIS CORPORATION
4-3
4 Using the HDE-200
4.2 Using the ECC App
Any user can monitor any HDE-200 through
the Exporter Control Center software (ECC app)
running on a studio computer. Any HDE-200 Ex-
porter in the network can be monitored, or moni-
tored and controlled, depending upon the creden-
tials of the logged in user. User credentials are set
using the facility’s normal system login names.
When the user is assigned to an HDE-200 User
Group, as defined by a computer administrator
when the ECC app was installed, then they will
have their assigned level of access. If the user
logged into the computer is not set as an HDE-
200 User, and they start the ECC app they will
have No Credentials access.
NOTE: When the ECC app is in-
stalled, security is NOT ACTIVE
and any user is a Commissioner.
Once the ECC app, the HDE-200s,
and the User Groups have been con-
figured, it is important to click the
Enable Security button on the
HDE-200
Preferences window to
activate User accounts. Until this is
done any ECC app user has full ac-
cess to change any setting on any
HDE-200!
To start the ECC app, double-click
its icon on the desktop. A program
shortcut is also added to the Windows
Programs menu. Click Start > Programs > Harris
Corp >
FlexStar > HDE-200 Control Center .
The main program window, shown on the next
page, opens up showing the name of the active
HDE-200 at the top of the window, above the menu
items. When first opened (No Device) will be
shown until an HDE-200 is selected.
To select an
HDE-200, click
De-
vice
> Select
Device
to open the
Exporter Device
Browser window. It lists all of the Harris HDE-
200s detected on the local network. Double-click
on a device name to select that HDE-200, or click
to highlight the name, then click OK , or press En-
ter
, to select that HDE-200 and close the window.
The selected HDE-200’s current status and con-
figuration information is sent to that ECC app. If
audio is going through the HDE-200, the audio
meters will immediately show the audio levels for
the Analog and Digital Main Programs.
If no HDE-200s are shown, then the ECC app
Preferences may not be set up properly. See page
3-21 about the System > Preferences... menu item.
ECC App Location in the Start Menu
ECC App Preferences Pop-Up Window
with the Enable Security Button
ECC App, Device Browser Window