Installation manual

ManualsBrandsBroadcast Devices ManualsComputer equipmentAES-200

Revision F • 3/12

HARRIS CORPORATION

5-10

5 Service

7. Click

to open the

Select Installation

Folder

window. For best results, use the de-

fault file location. Before continuing, set the

program access. Select

Everyone

so that mul-

tiple users can log into the computer and

use ECC. Continue the installation by click-

ing

on this and the following screen.

Once the installation completes, click

to close the installer window.

8. The ECC program automatically leaves the

four Windows user groups as they were from

the previous version of the program. If new

users need to be added or others removed,

follow the instructions on page 3-3 to set

user access to the ECC program’s features.

NOTE: The ECC program requires

Microsoft .NET Framework Version

2.0 Service pack 1. It can be down-

loaded from Microsoft’s website

(http://www. microsoft.com).

5.5 Replacing Assemblies

Should the DSP assembly (PRE99-1820) or

CPU assembly (PRE99-1815) require replace-

ment, they must be “paired-up” before use.

NOTE: Unplug the HDE-200 from the

Ethernet network, before applying

power, if either the CPU or DSP as-

semblies have been replaced.

When power is first applied to the HDE-200,

the CPU performs a scan of the local IP network

subnet looking for the presence of the DSP as-

sembly. Once the DSP assembly is found, the IP

address for that DSP board is automatically up-

dated to the DSP IP address that had been previ-

ously recorded by the CPU. Two scenarios can

occur, depending upon which assembly was re-

placed.

Scenario 1Scenario 1

Scenario 1: The CPU is replaced.

The existing DSP IP address is returned to

the factory default (10.10.10.22).

Scenario 2Scenario 2

Scenario 2: The DSP assembly is replaced.

The new DSP assembly will be changed

to the IP address that was assigned to the

replaced DSP assembly.

Note that the pairing process will take a bit

longer than the typical startup duration (could last

up to 5 minutes). This is normal for this pairing

process. The HDE-200 will automatically restart

again after the DSP assembly has been found and

paired with the CPU.

If the HDE-200 continually restarts, this is an

indication that the CPU is not able to pair up with

the DSP. This could be due to the CPU detecting

another HDE-200 on its local network. If this

occurs, the CPU will purposely refuse to perform

the pairing process. In this case, disconnect all

network cables from the HDE-200.

If a USB Flash Drive is connected—before start-

ing the Boot process, a boot log file will be written

to the Flash Drive. This will give a progress indi-

cation for the pairing process. Contact Harris Tech-

nical Support if continuous restarting occurs even

with the network cables disconnected.

Once the pairing is complete, review the IP ad-

dress assignments using HDE-200 Control Cen-

ter. Make any IP address adjustments that may

be necessary. Once all the network settings match

their previous settings, the connection to the Eth-

ernet network can be restored.