User's Manual

4 Dismounting the Transmitter

Caution

When using a power pack, make sure that the maximum supply current is at

least 8 A and the output voltage matches the input voltage range of the

CT2440ARINC transmitter.

Failure to comply with these requirements may cause fatal damage to the

power pack and/or CT2440ARINC.

You must use original cables. If you have questions please contact BMS

customer service.

Before connecting the 28V DC power supply cable, ensure all other equipment,

esp. the antenna, is connected.

4 Dismounting the Transmitter

Before you start dismounting the system make sure it is powered down. Confirm

that the power switch on the control panel is shifted to position “OFF”.

 Unplugging all cables

1. Unplug the power cables of the transmitter and the control panel first

2. Unplug all remaining cables

 Remove the components

3. Release the retaining screws of the transmitter and the control panel

4. Remove the control panel and the transmitter