User's Manual

14
5 Controlling the System 3.2 Mounting Instructions
5 Controlling the System
The whole system is controlled through the control panel located in the cockpit.
There are two types of control panels available. One version controls the antenna
actuator, the other does not.
Figure 10: Control panel with actuator
switch
Figure 11: Control panel without
actuator switch
INBUILT DISPLAY
The inbuilt display show different configuration parameters, the current
transmitter state, or alarm messages.
ROTARY KNOB
Use the rotary knob to select the different configuration parameters like “CH”,
“SCRAMBL”, and “RF LEVEL”.
 Preset selection
1. Press the rotary knob labelled “TUNE” for approximately two seconds
2. Turn the knob until “CH” is shown
3. Press the knob for approximately two seconds
4. Turn the knob until the desired preset number is shown
5. The transmitter loads the settings
6. Press the rotary knob for approximately two seconds to select the loaded
configuration
Note
If you press the rotary knob short the transmitter discards your selection.
Note
The programming of the different presets must be done through a computer and
configuration software.
 Scrambling
1. Press the rotary knob labelled “TUNE” for approximately two seconds
2. Turn the knob until “SCRAMBL” is shown
3. Press the knob for approximately two seconds to activate or deactivate
scrambling