User's Manual

Chapter 4: Operating the Equipment
Reference Guide: CT6020HD Page 22
March 09
3.10 Data Freq (10) (optional)
In the sub menu “Data Freq” the frequency of the data receiver can be set. However,
this setting is only valid for those models of the CT6020HD Series, which have
integrated data receivers for remote operation of the camera installed.
At the bottom of the display a bar is displayed. This is an indicator of UHF receive
strength, the “stronger” the bar the “stronger” the signal at the antenna.
The frequency may be changed in 10Khz steps.
Please be aware that the RX frequency will have to match the TX frequency of the UHF
data transmitter to enable remote operation of the camera.
To edit the data freq sub-menu press Enter-Button for 2 seconds.
Use the Up- and Down-Buttons for navigation and select the desired data freq by
pressing the Enter-Button.
To exit this submenu press Enter-Button.
3.11 Output Power (11)
In the sub menu “Output Power” you can adjust the power output. The more power is
selected the further is the distance the signal can be transferred. There are three
different power settings:
• LOW (10mW)
• MEDIUM (100mW)
• HIGH (200mW)
UHF Data Receive
Quality ‘bar’