Installation Instructions

TAA-101/TAA-101S Antenna Actuator Manual | Doc. No. 605169301 Rev. M
Broadcast Microwave Services, Inc. 21
3 INSTALLATION/SETUP
NOTE: Installation should only be performed by an FAA Certified A/P or Avionics Technician.
Each component should be installed in compliance with FAA regulations and accepted industry practices.
Some antenna mounts have been granted STC authorization by the FAA for particular aircraft; other
installations may require additional inspection/authorization. All equipment is to be installed based on the
following wiring diagram.
CAUTION: DO NOT use right-angle connectors or adapters on the RF Power Out cable assemblies.
Right-angle connectors may have significant RF power loss at the operating frequencies of this
system.
Figure 18. TAA-101 interconnect diagram
The TAA-101 and TAA-101S are side-specific. The side of the aircraft on which the TAA-101/TAA-101S
is to be installed is specified at the time of equipment order. The order of installation is as follows:
1. Decide where components will be located.
2. Install mounting bracket.
3. Install deployment control unit.
4. Route cables and terminate.
5. Install omni antenna.