Installation Instructions

TAA-101/TAA-101S Antenna Actuator Manual | Doc. No. 605169301 Rev. M
Broadcast Microwave Services, Inc. i
Document Revision History
Initial release 2006 Rev. -
Subsequent updates 2006-2008 Rev. A through G
Added Figure 9, Caution, page 15 March 2009 Rev. H
Added installation and removal tool instructions, starting page 18 October 2009 Rev. J
Updated max speed figure to correspond to STC. January 2010 Rev. K
Updated speed, deployment figures based on new calculations; added drawings March 2010 Rev. L
Included TAA-SM-22 (P/N 8001272972) November 2010 Rev. M
Adjusted RF exposure distance due to latest test reports August 2011 Rev. N
Conventions Used in This Manual
NOTE: Notes provide supplementary information. They are highlighted for emphasis, as in this
example, and are placed immediately after the relevant text.
CAUTION: Cautions give information which, if strictly followed, will prevent damage to equipment or
other goods. They are boxed for emphasis, as in this example, and are placed immediately preceding
the point at which the reader requires them.
WARNING: Warnings give information which, if strictly observed, will prevent personal injury or
death, or damage to personal property or the environment. They are boxed and shaded for emphasis,
as in this example, and are placed immediately preceding the point at which the reader requires
them.
ATTENTION!
CAUTION: DO NOT use right-angle connectors or adapters on the RF Power Out cable assemblies.
Right-angle connectors may have significant RF power loss at the operating frequencies of this
system.
CAUTION: FOR ALL BMS TRANSMITTERS: Operation of this product generally requires a license.
It is the responsibility of the user to obtain all required operating licenses.
FOR PRODUCTS AWAITING FCC CERTIFICATION: This device has not been authorized as required
by the rules of the US Federal Communications Commission. This device is not, and may not be,
offered for sale or lease, or sold or leased, in the US until authorization is obtained.
NOTE: Actual Acceptance Test Procedure (ATP) Test Data results by product serial number are
shipped with all units and indicate the equipment to be operating within advertised specifications.
Read and Follow Instructions
All safety and operating instructions should be read before this product is operated. All operating and use
instructions should be followed. This manual should be retained for future reference.
EMC Compliance
This equipment is certified to the EMC requirements detailed in the technical specifications. To maintain
this certification, only use the cables supplied or if in doubt contact BMS Customer Service.