User's Manual

3 Installing the Transmitter

Note

Operators are advised to always confirm that their application complies with the

requirements of the relevant frequency authority. Frequency allocations are

subject to assignation by national or local authorities. Most require individual

licences for operation. Contact details for EU authorities can be found at

http://ec.europa.eu/enterprise/rtte/spectr.htm

3 Installing the Transmitter

Warning

The VDE01000 regulations must be observed during the installation and

operation of the equipment.

Caution

 Protect the unit from wet and damp conditions.

 Avoid unnecessary jolting and movement during transportation and

operation of the unit.

 Ensure that there is adequate ventilation during installation and operation

to guarantee appropriate cooling of the unit.

 Before commencing operation, all necessary configuration of the

CT6540ARINC should be concluded. Transmission efficiency should be

exhaustively tested.

 All necessary cabling should be in place before the unit is switched on.

Operating the transmitter without having the antenna connected may harm

the device.

 A valid video signal must be present on the selected video input of the

CT6540ARINC during switch on.

 Please ensure that the safety instructions are adhered to when you

connect the CT6540ARINC. See the following chapters.

Warning

To ensure that the unit is vented properly, air circulation through the unit must

be guaranteed. In any installation a minimum space of 20mm must be held over

and underneath the housing.