User's Manual

10
3 Installing the Transmitter
7. Connect available video source to the BNC sockets labelled “CVBS
8. Connect all available audio sources to the connector labelled “AUDIO”
9. Connect optional devices to the output labelled “ASI out” if necessary
10. Connect other devices to the sockets labelled “COM” and “ARINC” if
necessary
Note
The ports “COM” and “ARINC” are subject of customised applications. Please
refer to separate instructions.
 Installing the control panel
There are two types of control panels available. One version controls the antenna
actuator, the other does not.
Figure 8: Control panel connectors (with
actuator control)
Figure 9: Control panel connector
(without actuator control)
11. Connect the antenna actuator cable to the socket labelled “ACTUATOR” if
available
12. Connect the transmitter to the socket labelled “COM”
13. Connect the power supply to the socket labelled “POWER” if available
14. Fix the control panel in the cockpit centre console with the four retaining
screws
15. After all connections are made securely, connect the power supply to the
socket labelled “28V DC” transmitter
Caution
When using a power pack, make sure that the maximum supply current is at
least 8 A and the output voltage matches the input voltage range of the
CT6540ARINC transmitter.
Failure to comply with these requirements may cause fatal damage to the
power pack and/or CT6540ARINC.
You must use original cables. If you have questions please contact BMS
customer service.
CT6540ARINC