User's Manual

6051412900 Rev -
21
INPUT/OUTPUT CHARACTERISTICS
Composite Video (CVBS)
Type Composite Video Baseband Signal (CVBS)
Systems NTSC 525 lines / 60 Hz / Fsc = 3.58 MHz
PAL 625 lines / 50 Hz / Fsc = 4.43 MHz
Standard ITU-R BT 470-6
Impedance 75 Ohms
Component Video (YUV)
Type YUV (formerly Y / Pb / Pr)
Systems NTSC 525 lines / 60 Hz
PAL 625 lines / 50 Hz
Standard ITU-R BT 470-6
Impedance 75 Ohms
Analog Audio
Type Balanced Line
Channels 2 separate channels (Left and Right)
Nominal input level Adjustable from –10 dBu to +4 dBu (0 dBu = 775 mV rms)
Headroom 12 dB
Sampling frequency 48 kHz – 20 bits
Frequency response 30 Hz – 20 kHz (+/- 1dB)
Signal-to-Noise Ratio 65 dBA
Diaphony 60 dBA
Total Harmonic Distortion < 0.1 % @ 1 kHz
Impedance > 10 K ohms
If a low impedance input (600 Ohms) is required, the user can make a specific interface cable with 600 Ohm resistors
between the +/– lines of balanced audio conductors.
Data Input
Type RS-232
Possible Bitrates 9600, 4800 and 1200 bauds (selectable)
Format N, 8, 1 (1 start bit, 8 data bits, 1 stop bit, no parity)
Protocol None (no XON/XOFF)
For full bandwidth (100% continuous) data, set the decoder to a higher bit rate than the CCII to alleviate
losses due to asynchronous transmission.
Remote Control Port
Type RS232
Bit rate 9600 Bps
Format N, 8, 1 (1 start bit, 8 data bits, 1 stop bit, no parity)
Maximum cable length 100 m
Format and protocol Proprietary
It is recommended to use a shielded DB9 cable in order to increase reliability.