Datasheet
ACPL-M43T
Automotive Wide Operating Temperature 1MBd Digital Optocoupler
in a 5-Pin Surface Mount Plastic Package
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The ACPL-M43T is a single channel, high temperature,
high CMR, high speed digital optocoupler in a ve lead
miniature footprint specically used in the automotive
applications. The SO-5 JEDEC registered (MO-155) pack-
age outline does not require “through holes” in a PCB. This
package occupies approximately one-fourth the footprint
area of the standard dual-in-line package. The lead prole
is designed to be compatible with standard surface mount
processes.
This digital optocoupler uses an insulating layer between
the light emitting diode and an integrated photon detector
to provide electrical insulation between input and output.
Separate connections for the photodiode bias and output
transistor collector increase the speed up to a hundred
times over that of a conventional photo-transistor coupler
by reducing the base-collector capacitance.
The ACPL-M43T has an increased common mode transient
immunity of 30kV/µs minimum at V
CM
= 1500V over ex-
tended temperature range.
Functional Diagram
Features
• High Temperature and Reliability IPM Driver for
Automotive Application.
• 30 kV/µs High Common-Mode Rejection
at V
CM
= 1500 V (typ)
• Compact, Auto-Insertable SO5 Packages
• Wide Temperature Range: -40°C ~ 125°C
• High Speed: 1MBd (Typ)
• Low LED Drive Current: 10mA (typ)
• Low Propagation Delay: 300ns (typ)
• Worldwide Safety Approval:
− UL1577 recognized, 3750Vrms/1min
− CSA Approved
− IEC/EN/DIN EN 60747-5-2 Approved
Applications
• Automotive IPM Driver for DC-DC converters
and motor inverters
• CANBus Communications Interface
• High Temperature Digital/Analog Signal Isolation
• Power Transistor Isolation
I
F
SHIELD
6
5
4
GND
V
CC
1
3
V
O
I
CC
V
F
I
O
ANODE
CATHODE
+
-
Truth Table
LED
ON
OFF
Vo
LOW
HIGH
Note: The connection of a 0.1 µF bypass capacitor
between pins 4 and 6 is recommended.
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.