User's Manual

162 Adding and Replacing Parts
www.dell.com | support.dell.com
FILE LOCATI ON: S:\SYSTEMS\Pebble\UG\A00\English\r_r.fm
DELL CONFI DENTI AL – PRELI MI NARY 1/29/03 – FOR PROOF ONLY
3 If the computer is connected to a docking device (docked), undock it.
See the documentation that came with your docking device for
instructions.
4 Disconnect the computer from the electrical outlet.
5 Wait 10 to 20 seconds, and then disconnect any attached devices.
6 Remove any installed PC Cards and the battery.
NOTICE: Handle components and cards by their edges, and avoid touching
pins and contacts. Ground yourself by touching a metal connector on the back
of the computer. Continue to ground yourself periodically during this
procedure.
7 Turn the computer over, loosen the captive screws on the memory
module/modem cover, and then remove the cover.
8 If a modem is not already installed, go to step 9. If you are replacing a
modem, remove the existing modem:
a Remove the screw securing the modem to the system board, and
set it aside.
b Pull straight up on the attached pull-tab to lift the modem out of
its connector on the system board, and disconnect the modem
cable.
1
2