User's Manual

Adding and Replacing Parts 165
FILE LOCATI ON: S:\SYSTEMS\Pebble\UG\A00\English\r_r.fm
DELL CONFI DENTI AL – PRELI MI NARY 1/29/03 – FOR PROOF ONLY
1 Connect the keyboard connector to the interface connector on the
system board.
2 Insert the five securing tabs on the keyboard into their respective slots
in the palm rest.
3 Replace the two screws at the top of the keyboard.
4 Replace the center control cover and snap it down so that it is flush
with the palm rest.
Adding a M ini PCI Card
If you ordered a Mini PCI card with your computer, the card is already
installed.
CAUTI ON: Before working inside your computer, read the safety
instructions in your
System I nformation Guide .
1 Ensure that the work surface is flat and clean to prevent scratching the
computer cover.
2 Save and close any open files, exit any open programs, and then shut
down the computer.
3 If the computer is connected to a docking device (docked), undock it.
See the documentation that came with your docking device for
instructions.
4 Disconnect the computer from the electrical outlet.
5 Wait 10 to 20 seconds, and then disconnect any attached devices.
6 Remove any installed PC Cards and the battery.
NOTI CE: Handle components and cards by their edges, and avoid touching
pins and contacts. Ground yourself by touching a metal connector on the back
of the computer. Continue to ground yourself periodically during this
procedure.
7
Remove the keyboard.
8 If a Mini PCI card is not already installed, go to step 9. If you are
replacing a Mini PCI card, remove the existing card:
a Disconnect the Mini PCI card from the attached cables.