User's Manual Part 2

2–30 Hardware and Software Guide

Power

DRAFT Revised: 8/24/04

File: Chap2.fm

PN: HP-367186-001

hp CONFIDENTIAL

August 24, 2004 4:01 pm

4. Select OK.

5. Disconnect the tablet PC from the external power source, but

do not turn off the tablet PC.

6. Run the tablet PC on battery power until the battery pack is

fully discharged. The battery light begins to blink when the

battery pack has discharged to a low-battery condition. When

the battery pack is fully discharged, the battery light is turned

off and the tablet PC shuts down.

Recharging the Battery Pack

To recharge the battery pack:

1. Connect the tablet PC to external power and maintain the

connection until the battery pack is fully recharged. The

battery light on the tablet PC is turned off.

You can use the tablet PC while the battery pack is recharging

but the battery pack will charge faster if the tablet PC is off.

2. If the tablet PC is off, turn it on when the battery pack is fully

charged and the battery light is turned off.

3. Access the Power Schemes tab by selecting Start > Control

Panel > Power Options > Power Schemes tab.

4. Refer to the settings you recorded earlier. Reenter the settings

that you recorded for the items in the Plugged In column and

the Running on Batteries column.

5. Select OK.

CAUTION: After calibrating the battery pack, reenable Hibernation.

Failure to reenable Hibernation may result in a complete battery drain and

potential data loss.

To reenable Hibernation, select Start > Settings > Control Panel >

Power Options > Hibernate tab. Select the Enable Hibernation

check box, and then select Apply.

367426-xx1.book Page 30 Tuesday, August 24, 2004 4:02 PM