User's Manual Part 6

MultiBoot
Hardware and Software Guide 10–3
DRAFT Revised: 8/24/04
File: Chap10.fm
PN: HP-367186-001
hp CONFIDENTIAL
August 24, 2004 4:02 pm
Enabling Bootable Devices in
Computer Setup
The tablet PC can start up from a USB device or the NIC only if
that device has been enabled for inclusion in MultiBoot.
To enable a device or location for inclusion in MultiBoot:
1. Open Computer Setup by turning on or restarting the tablet
PC. Press
f10 while the F10 = ROM Based Setup message is
displayed in the lower-left corner of the screen.
❏ To change the language, press f2.
❏ For navigation instructions, press f1.
2. To enable bootable media in USB drives or in drives inserted
into an optional docking device, use the arrow keys to select
Advanced > Device options. Then select Enable USB
legacy support.
-or-
To enable a NIC, select Security > Device security.
3. Save your preferences and exit Computer Setup, by using the
arrow keys to select File > Save changes and exit, and then
follow the instructions on the screen.
Your preferences are set when you exit Computer Setup and
they take effect when the tablet PC restarts.
✎
To connect a NIC to a Preboot eXecution Environment (PXE) or
Remote Program Load (RPL) server during startup without using
MultiBoot, quickly press
f12 when the Network Service Boot
message appears in the lower-right corner of the screen.
367426-xx1.book Page 3 Tuesday, August 24, 2004 4:02 PM