User's Manual

Adding and Replacing Parts 127
NOTICE: When the hard drive is not in the computer, store it in protective antistatic
packaging. See "Protecting Against Electrostatic Discharge" in the Product
Information Guide.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use
excessive force, you may damage the connector.
5 Slide the hard drive into the bay until it is fully seated.
6 Replace and tighten the screws.
7 If the new hard drive is not already pre-imaged, install the operating
system and drivers for your computer.
See "Restoring Your Operating
System" on page 118 and "Reinstalling Drivers and Utilities" on page 116.
1 hard drive screws (2) 2 hard drive
2
1