User's Manual

Regulatory Statements for BCM92070MD_REF12
USA-Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by tuning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna
-Increase the distance between the equipment and the receiver.
-Connect the equipment to outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Caution: Exposure to Radio Frequency Radiation.
To comply with FCC RF exposure compliance requirements, this device must not be co-
located or operating in conjunction with any other antenna or transmitter within a host
device, except in accordance with FCC multi-transmitter product procedures.
If the module is installed in portable hosts, where the separation distance between
radiating elements and the user is less than 20cm, additional equipment authorization
procedure to address RF exposure compliance shall apply. If the module is installed with
other transmitting devices which can transmit simultaneously with this device and
antenna-to-antenna distance is less 20cm, assessing RF exposure compliance with
multiple transmitters within a host device shall be performed based upon FCC
requirements.
Note: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interferences, and (2)
this device must accept any interference received, including interferences that may cause
undesired operation.
End product must be labeled with “Contains FCC ID: QDS-BRCM1049”.