User's Manual

OEM Installation Guidance Document
For Broadcom 802.11a/b/g/n WLAN + Bluetooth Card, BCM943241NG1630
FCC ID: QDS-BRCM1073; IC: 4324A-BRCM1073
Page 2 of 9
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
CAUTION: (this only applicable to 5GHz device)
This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz
frequency range. FCC requires this product to be used indoors for frequency range 5.15
to 5.25 GHz to reduce the potential for harmful interference to co-channel Mobile
Satellite systems.
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to
5.85 GHz bands. These radar stations can cause interference with and/or damage this
device.
System integrators must include the FCC ID on the end product.
FCC Radio-Frequency Exposure & Approval Conditions:
1. Antennas must be installed in the display section or underneath the keyboard in
Netbook/notebook/laptop/tablet computers to provide at least 5mm separation distance
from the transmitting antenna to the body of user , or any other person during normal
operating condition.
-For portable applications, the WLAN antennas used must be the same type of antennas
as the original Equipment Authorization.
- For standalone SAR testing, the antenna is mounted on lossless foam material for
testing. In order to use Broadcom modular approval, PC–OEMs must install antennas
with non–conductive materials surrounding the antenna.
2. The antenna(s) used for this transmitter must not be collocated or operating in
conjunction with any other antenna or transmitter within a host device, except in
accordance with FCC multi-transmitter product procedures. Please contact Broadcom for
instructions.
3. The regulatory label on the final system must include the statement: “Contains FCC
ID: QDS-BRCM1073 and IC: 4324A-BRCM1073” or using electronic labeling method
as documented in KDB 784748.
4. The final system integrator must ensure there is no instruction provided in the user
manual or customer documentation indicating how to install or remove the transmitter
module except such device has implemented two-ways authentication between module
and the host system.