User's Manual

OEM Installation Guidance Document
For Broadcom 802.11a/b/g/n WLAN + Bluetooth Card, BCM943241NG1630
FCC ID: QDS-BRCM1073; IC: 4324A-BRCM1073
Page 5 of 9
Caution: Exposure to Radio Frequency Radiation.
To comply with RSS 102 RF exposure compliance requirements, for mobile
configurations, a separation distance of at least 20 cm must be maintained between the
antenna of this device and all persons. This device must not be co-located or operating in
conjunction with any other antenna or transmitter.
Pour se conformer aux exigences de conformité 102 RSS RF exposition, pour des
configurations mobiles, une distance de séparation d'au moins 20 cm doit être maintenue
entre l'antenne de cet appareil et toutes les personnes. Cet appareil ne doit pas être co-
localisés ou fonctionnant en conjonction avec une autre antenne ou transmetteur.System
integrators must include the IC ID on the end product. Industry Canada user statements
should be provided in both English and French, at the time each product is offered for
sale or lease in Canada.
For portable configurations, antennas must be installed in the display section or
underneath the keyboard in Netbook/notebook/laptop/tablet computers to provide at least
5mm separation distance from the transmitting antenna to the body of user, or any other
person during normal operating condition.
Pour les configurations portables, les antennes doivent être installées dans la section
d'affichage ou sous le clavier netbook / notebook / ordinateur portable / tablette
ordinateurs pour fournir au moins 5 mm distance de séparation entre l'antenne d'émission
sur le corps de l'utilisateur, ou toute autre personne au cours de fonctionnement normal .
3. Europe - EU Restrictions
This equipment needs to be marked with the 0560 symbol and can be used
throughout the European community.
Marking by the symbol indicates that usage restrictions apply.
Information to be supplied to the users:
802.11a Restrictions:
- This product is for indoor use only when using channels 36, 40, 44, 48, 52, 56, 60, or 64 (5150–
5350 MHz).
- DFS and TPC must remain enabled to ensure product compliance with EC regulations.
- To ensure compliance with local regulations, be sure to select the country in which the access
point is installed.