User's Manual

Industry Canada(IC)
2. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
1. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
devicemust accept any interference, including interference that may cause undesired
operation of the device.
3. This device has been tested for compliance with FCC RF Exposure (SAR) limits in typical
flat configurations.
Ce dispositif a été testé pour la conformité aux normes FCC RF exposition ( SAR) dans des
configurations limites plats typiques .
In order to comply with SAR limits established in the RSS-102 & ANSI C95.1 standards, it is
recommended when using a 802.11 a/b/g/n/ac WLAN+Bluetooth PCI-E Mini Card that the
integrated antenna is positioned more than 0cm from your body or nearby persons during
extended periods of operation. If the antenna is positioned less than 2.5cm from the user, it is
recommended that the user limit the exposure time.
In order to SAR comply with restriction established in the RSS - 102 c95.1 et normes ANSI, it
is recommended lors de l'utilisation de 802.11 A / B / G / N / AC + de réseau local sans fil
Bluetooth PCI - E à une mini - carte that the Integrated antenne est positionné more than from
your body ou à proximité de la cm Periods of Persons during à étendre ses activités.Si
l'antenne est positionné inférieure à 2,5 cm from the user, it is recommended that the user limit
the Exposure Time.