User's Guide

OEM Installation Guidance Document
For Broadcom BCM94356Z
FCC ID: QDS-BRCM1085; IC: 4324A-BRCM1085
Page 2 of 9
-Connect the equipment to outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
High power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to
5.85 GHz bands. These radar stations can cause interference with and/or damage this
device.
System integrators must include the FCC ID on the end product.
FCC Radio-Frequency Exposure & Approval Conditions:
1. Antennas must be installed in the display section or underneath the keyboard in
Notebook/notebook/laptop computers to provide at least 5mm separation distance from
the transmitting antenna to the body of user, or any other person during normal operating
condition. Configuration in tablets must be with at least 10mm antenna-to-enclosure
separation distance.
-For portable applications, the WLAN antennas used must be the same antennas as in this
filing. The distance between two antennas (Chain 1 and Chain 2) is at least 5cm.
2. The antenna(s) used for this transmitter must not be collocated or operating in
conjunction with any other antenna or transmitter within a host device, except in
accordance with FCC multi-transmitter product procedures.
4. Only those antennas with same type and lesser gain filed under this FCC ID number
can be used with this device.
5. The regulatory label on the final system must include the statement: “Contains FCC
ID: QDS-BRCM1085 and ID: 4324A-BRCM1085 “or using electronic labeling method
as documented in KDB 784748.
6. The final system integrator must ensure there is no instruction provided in the user
manual or customer documentation indicating how to install or remove the transmitter
module except such device has implemented two-ways authentication between module
and the host system.
7. The final host manual shall include the following regulatory statement:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy. If not installed and used in
accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a