Datasheet

11
Absolute Maximum Ratings* (No Derating Required up to 85°C)
Parameter Symbol Package** Min. Max. Units Note
Storage Temperature T
S
-55 125 °C
Operating Temperature† T
A
-40 85 °C
Average Forward Input Current I
F
Single 8-Pin DIP 20 mA 2
Single SO-8
Widebody
Dual 8-Pin DIP 15 1, 3
Dual SO-8
Reverse Input Voltage V
R
8-Pin DIP, SO-8 5 V 1
Widebody 3
Input Power Dissipation P
I
Widebody 40 mW
Supply Voltage V
CC
7 V
(1 Minute Maximum)
Enable Input Voltage (Not to V
E
Single 8-Pin DIP V
CC
+ 0.5 V
Exceed V
CC
by more than Single SO-8
500 mV) Widebody
Enable Input Current I
E
5 mA
Output Collector Current I
O
50 mA 1
Output Collector Voltage V
O
7 V 1
Output Collector Power P
O
Single 8-Pin DIP 85 mW
Dissipation Single SO-8
Widebody
Dual 8-Pin DIP 60 1, 4
Dual SO-8
Lead Solder Temperature T
LS
8-Pin DIP 260°C for 10 sec.,
(Through Hole Parts Only) 1.6 mm below seating plane
Widebody 260°C for 10 sec.,
up to seating plane
Solder Reow Temperature SO-8 and See Package Outline
Prole (Surface Mount Parts Only) Option 300 Drawings section
*JEDEC Registered Data (for 6N137 only).
**Ratings apply to all devices except otherwise noted in the Package column.
†0°C to 70°C on JEDEC Registration.
Recommended Operating Conditions
Parameter Symbol Min. Max. Units
Input Current, Low Level I
FL
* 0 250 µA
Input Current, High Level
[1]
I
FH
** 5 15 mA
Power Supply Voltage V
CC
4.5 5.5 V
Low Level Enable Voltage† V
EL
0 0.8 V
High Level Enable Voltage† V
EH
2.0 V
CC
V
Operating Temperature T
A
-40 85 °C
Fan Out (at R
L
= 1 kΩ)
[1]
N 5 TTL Loads
Output Pull-up Resistor R
L
330 4 k Ω
*The o condition can also be guaranteed by ensuring that V
FL
≤0.8 volts.
**The initial switching threshold is 5 mA or less. It is recommended that 6.3 mA to 10 mA be used for best performance and to permit at least a
20% LED degradation guardband.
†For single channel products only.